Chevrolet Corvette C6R No.8 GT Open 2013 Carrera Digital 30679

Kickermann Tuning Advanced Carrera Digital 132

What is the kicker man doing with the car?

-he mounts Ortmann tires
-he installs Frankenslot guide keel for Carrera (if you are driving a wooden track, please let me know!)
-he oils the engine and the axle bearings and applies special grease to the axle gear
-he lets the engine run in for 2 hours
-he aligns the vehicle (not the axles)

Kickermann Tuning Expert Carrera Digital 132

What does Kickermann do with the car?

-he installs a tuning axle from slot.it at the rear
-he mounts Ortmann tires
-he glues and grinds the Ortmann tires
-he mounts Frankenslot guide keel for Carrera (If you drive on a wooden track, please let us know!)
-he installs a tuning motor with 25000 rpm at 12V
-he installs a new motor pinion
-he oils the motor and the axle bearings and applies special grease to the axle gear wheel
-he lets the engine run in for 2 hours
-he aligns the vehicle
-he measures the wheelbase and then aligns the axles
-he mounts a professional axle gear

Kickermann Tuning Profi

What does Kickermann do with the slotcar?

-he mounts a Slot it rear axle
-he mounts slot it aluminum rims at the rear
-he mounts Ortmann tires front and rear
-he glues and grinds the rear Ortmann tires
-he glues a set of sponge rubber tires for the rear on a separate set of rims
-he cuts the rear sponge rubber tires to the correct width and grinds them to the correct width
-he optimizes the edges of the sponge rubber tires and installs rim inserts in the additional wheel set
-he glues a set of sponge rubber tires for the front on a separate set of rims
-he glues the front sponge rubber tires and cuts them to the correct width
-he grinds the sponge rubber front tires
-he mounts Frankenslot guide keels for Carrera (if you drive on a wooden track, please let us know!)
-he installs a tuning motor with 25000 rpm at 12V
-he installs a new motor pinion
-he oils the motor and the axle bearings and applies special grease to the axle gear wheel
-he lets the engine run in for 2 hours
-he aligns the vehicle
-he measures the wheelbase and then aligns the axles
-he installs a professional axle gear and adds another one for an optional gear ratio change
-he installs ABEC 5 ball bearings at the front and rear, cleans them and then oils them again
-he lead-coats the entire vehicle for optimum performance
-he tests the finished vehicle on our race track and then optimizes it
-he carries out a final function and performance test